![background image](http://html.mh-extra.com/html/aeroqual/aqs-1/aqs-1_user-manual_2862866013.webp)
MRK-D-0048 V4
Aeroqual Dust Sentry / AQS User Guide
Page | 13
IMPORTANT
The Particle Monitor ships from the factory with a thin film of tape or coloured
cap which protects the inlet, this must first be removed as shown in
Figure 2-3 Remove the protective tape or cap from the PM inlet
Figure 2-4 Gently feed in the power cable and over the particle engine mounting bracket on the left. The
aluminium tube must push all the way into the PM module.
IMPORTANT
Ensure sure that the aluminium inlet tube is pushed all the way into the
optical engine block.
If the aluminium tube does not fully push down in to the optical engine block, then create
more length in the aluminium tube by removing the grey retaining nut and then sliding up the
rubber grommet on the top of the inlet. Replace the nut after you have done this.
Remove
protective
tape or
coloured cap