MRK-D-0048 V4
Aeroqual Dust Sentry / AQS User Guide
Page | 26
4.4 Resetting the communication settings back to factory settings
The monitor communication settings can be set back to factory defaults.
One situation where this might be useful is if the WIFI SSID name or password has been incorrectly
entered and therefore the ePC cannot establish a connection to the local WIFI network.
The WIFI settings can be set back to Access Point mode and the monitor will again appear as a WIFI
network with th
e SSID name “
Aeroqual AQM
”
and WIFI password “
Aeroqual
”
.
To achieve this you will need a USB flash drive.
1. Create a file on the flash drive called
.resetnetwork.aqm
(yes there is a “dot” at the beginning of
the file name).
The file extension must be
.aqm
it cannot be a .aqm
.txt
file.
In Windows OS you can create a new .txt document and give the file name
.resetnetwork.aqm
Check the Type column to make sure it is an .aqm file. You might need to unhide file extensions
and delete the .txt from the end of the file name. Figure 4-10 shows the correct file.
Figure 4-10 Create an empty file called .resetnetwork.aqm
2. Then insert the USB drive into any of the USB ports on the ePC.
3. Wait several minutes, the ePC will reboot automatically and then you should see a WIFI network
appear
called “
Aeroqual AQM
” with password
Aeroqual
.
You can then remove the USB stick.