Advanced Quick Zone XL, Installation, Commissioning & Operating Manual

Page: 16 / 68

16
3 INSTALLATION
3.1 SAFETY
Suppliers of articles for use at work are required under section 6 of the Health and Safety at Work Act 1974 to
ensure as reasonably as is practical that the article will be safe and without risk to health when properly used.
An article is not regarded as
properly used if it is used “without regard to any relevant information or advice”
relating to its use made available by the supplier.
It is assumed that the system, of which this control panel is a part, has been designed by a competent fire alarm
system designer in accordance with BS 5839 Part 1 and with regard to BS EN 54 parts 2 and 4 in the case of
control equipment and power supplies. Design drawings should be provided to clearly show the position of any
field devices and ancillary equipment.
This product should be installed, commissioned and maintained by, or under the supervision of, competent
persons according to good engineering practice and,
(i) BS 7671 (IEE wiring regulations for electrical installations)
(ii) Codes of Practice
(iii) Statutory requirements
(iv) Any instructions specifically advised by the manufacturer
According to the provisions of the Act you are therefore requested to take such steps as are necessary to
ensure that any appropriate information about this product is made available by you to anyone concerned with
its use.
This equipment is designed to be operated from 230V
AC
50/60 Hz mains supplies and is of Class I construction.
As such it must be connected to a protective earthing conductor in the fixed wiring of the installation. Failure to
ensure that all conductive accessible parts of this equipment are adequately bonded to the protective earth will
render the equipment unsafe.
These panels are designed to comply with the requirements of EN 54 part 2.
Installation of the panel should only be carried out by qualified personnel. The electronic components within the
panel can be damaged by static charge. Suitable precautions must be taken when handling circuit boards.
Never insert or remove boards or components, or connect cables, with the mains power on or batteries
connected.
This equipment must only be installed and maintained by a suitably skilled and
technically competent person.
THIS IS A PIECE OF CLASS 1 EQUIPMENT AND MUST BE EARTHED
Equipment Guarantee
This equipment is not guaranteed unless the complete system is installed and
commissioned in accordance with the laid down national standards by an approved and
competent person or organisation.
This product has been manufactured in conformance with the requirements of all
applicable EU Council Directives
www.acornfiresecurity.com
www.acornfiresecurity.com