6
1 Introduction
1.1 Standards
The
Lux Intelligent
Addressable Emergency Lighting Control Panels conform to the requirements of the
following standards and codes of practice:
BS5266-1:2011
Code of practice for emergency lighting
EN50172:2004 / BS5266-8:2004
Emergency escape lighting systems
Low Voltage Directive 2006/95/EC
EN60950-1: 2006 +A12:2011
Safety of information technology equipment
Electromagnetic Compatibility Directive 2004/108/EC
EN61000-6-3:2007 +A1:2011
Emissions, Class B
EN50130-4: 1995 +A1:1998 +A2: 2003 Immunity, Product Family Standard
EN50130-4: 2011
Immunity, Product Family Standard
1.2 Cautions and Warnings
STOP
BEFORE INSTALLATION
– Refer To the Ratings shown on the label inside the
product and to the ‘Specifications Chart’ in this document.
Please read this manual carefully. If you are unclear on any point DO NOT
proceed. Contact the manufacturer or supplier for clarification and guidance.
Only Trained service personnel should undertake the Installation, Programming
and Maintenance of this equipment.
This product has been designed to comply with the requirements of the Low
Voltage Safety and the EMC Directives. Failure to follow the installation
instructions may compromise its adherence to these standards.
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE DEVICES
This equipment is constructed with static sensitive components. Observe anti-
static precautions at all times when handling printed circuit boards. Wear an
anti-static earth strap connected to panel enclosure earth point. Before
installing or removing any printed circuit boards remove all sources of power
(mains and battery).
1.3 Description
This manual covers the installation, programming, commissioning and use of the Lx-9400 Addressable
Emergency Lighting Control Panel. Additionally, a User Guide (Document No. 680-070) is also available.
The Lx-9400 is a Multiple Loop, Addressable Emergency Lighting Control Panel with provision for up to four
signalling loops and is designed for use with Emergency Light Luminaires equipped with the Advanced
Electronics Pulse addressing and monitor PLU module.
The Lx-9800 is a Multiple Loop, Addressable Emergency Lighting Control Panel with provision for up to eight
signalling loops and is designed for use with Emergency Light Luminaires equipped with the Advanced
Electronics Pulse addressing and monitor PLU module
Install the panel, signalling loops, monitored output circuits, etc. in accordance with the instructions in
Section 2 and then program the operation in accordance with the instructions detailed in Section 4.
User operation is described in Section 3.
