11
2.2.3
Mounting the Enclosure
Firstly, remove the required knockouts for the
installation wiring. There are sufficient knockouts
on the top of the enclosure for all installation
wiring. In addition, there are knockouts at the top
of the back wall, if required, for rear entry cabling.
The diagram opposite shows the positions of the
four holes. Use all four positions to ensure the
panel is held securely to the wall.
Drill the required holes in the supporting wall
using a drill bit diameter 7.0 mm and plug with a
suitable 40mm long expansion plug. Affix the
panel to the wall with M5 screws (length 40mm)
or No.10 scr
ews (length 1½”).
Ensure that there is sufficient space to allow the
door to be opened when the panel is mounted.
Finally, use a brush to remove any dust or swarf
from inside the enclosure.
Enclosure Size and Fixing Point Dimensions
9400
450
380
35
25
385 340
Earth
Studs
x4
Cable Tie Anchor
Points x9
9400/D
450
380
35
25
475 405
Earth
Studs
x4
Cable Tie Anchor
Points x9
9800
450
380
35
20
515
370
950
2.2.4
Remounting the Chassis
Carefully replace the chassis and locate onto the upper two screws. Replace the bottom two screws and tighten
all four screws to hold the chassis securely to the back box.
Reconnect the chassis earth cable to the spade terminal in the rear of the enclosure.
