612806320L1-1B
Copyright © 2005 ADTRAN, Inc.
99
DLP-4
Verifying Communications Over an IP LAN
Introduction
When the 10/100BaseT/TX
MGMT
port is connected to a local area network (LAN), test steps must be
performed on the TRACER 6200 to ensure that the unit is communicating properly over the network. This
procedure outlines those steps.
Prerequisite Procedures
Before beginning this procedure, the unit should be physically connected to the LAN and the provisioning
tasks detailed in DLP-3,
Setting IP Parameters for the TRACER System
, on page 95 should be complete.
Tools and Materials Required
•
Access to a PC or other computer connected to the LAN
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
