TRACER 6000 Series Split System Manual
Section 5 User Interface Guide
612806320L1-1B
81
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
Figure 30 shows the Management/SNMP Port Configuration menu page, which contains the configuration
parameters for the 10/100BaseT/TX
MGMT
Ethernet interface and SNMP configuration parameters (from
both the local and remote TRACER units).
Figure 30. Management/SNMP Port Configuration
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> IP A
DDRESS
Lists the address assigned to the 10/100BaseT/TX
MGMT
Ethernet port. This address is in dotted decimal
notation (four decimal numbers, each in the range of 0 to 255, separated by periods). This value is set to
192.168.0.10
by default. Obtain the correct IP address from your LAN administrator.
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> N
ET
M
ASK
Defines which part of a destination IP address contains the network number. This address is in dotted
decimal notation (four decimal numbers, each in the range of 0 to 255, separated by periods). This value
is set to
255.255.255.0
by default. This part of the destination IP address is used along with the
TRACER IP address to determine which nodes must be reached through the default IP gateway.
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> D
EFAULT
G
ATEWAY
Defines or changes the default gateway. You will need a default gateway if the LAN contains multiple
segments. This address is in dotted decimal notation (four decimal numbers, each in the range of 0 to 255,
separated by periods). This value is set to
192.168.0.254
by default. Contact your LAN administrator for
the appropriate address.
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> MAC A
DDRESS
(Read Only) Displays the system Ethernet Media Access Control (MAC) address.
> M
ANAGEMENT
/SNMP P
ORT
C
ONFIGURATION
> SNMP M
ANAGEMENT
Contols SNMP management in the TRACER system. When set to
D
ISABLED
, the TRACER system does
not send SNMP traps. When set to
E
NABLED
, the TRACER system sends SNMP traps to configured
management systems.
