iFT Series Hardware Installation Manual
ADPRO
20
27817_08
Caution!
l
Before installing hard disks, stop the device. Switch it off and unplug the power cord.
l
Take all necessary precautions to prevent static discharges that may damage the device: use an
anti-static wristband, an anti-static mat…
l
The procedure below assumes that you are using a
new disk
, or, in case of a used disk, that you
will
format the used disk
and erase all recordings on it. If you want to install a used hard disk
while keeping the recordings on it, follow the instructions in the Tech Tip
Recovering Recordings
from Used HDDs
(29160).
To install a third hard disk in an iFT device, proceed as follows:
1.
Stop the device, switch off the power supply, and then remove the top cover: unscrew 2 screws at the front,
4 at the top, and 3 at the back.
2.
Fix the third disk on the mounting bracket (#17011920) using 4 disk screws (#17434080). Make sure that the
disk is on the correct side as shown in the image below.
3.
Before mounting the bracket with the disk in the XO device, arrange the required SATA power and data
cables so that you can access them when the bracket is in place.
