ADPRO
iFT Series Hardware Installation Manual
27817_08
17
To install a second hard disk, proceed as follows:
1.
Stop the device, switch off the power supply, and then remove the top cover: unscrew 2 screws at the front,
4 at the top, and 3 at the back.
2.
If the first disk is already installed, you have to remove it first: unplug its power and data cables, and
unscrew it from the bottom of the casing.
Caution!
If you tilt the casing, rest it carefully on the sides, but not on the back. You may damage the
connectors if you do.
3.
Fix the first and second hard disk together using the 2 hard disk brackets (#17011890 and #17011895) and
8 screws (#17434080) as shown below. Make sure that the mounting screw holes on hard disk 1 are on the
outside.
A
: bracket #17011890;
B
: L-shaped bracket #17011895
4.
Fix hard disk 1 to the bottom of the casing. For instructions depending on the model and hard disk capacity,
see
Installing the First Hard Disk
5.
Connect hard disk 1 to the power supply, and to the SATA1 connector on the motherboard with the SATA
cable (#16520877).
