ADC AVIDIA SWD4573I1, User Manual

Page: 130 / 658

Configuring ADSL Alarm Profiles
104 Avidia System Configuration and Management User Manual
C
ONFIGURING
ADSL A
LARM
P
ROFILES
ADSL alarm profiles determine the conditions that generate SNMP traps. When the configured
thresholds are met or exceeded, the SNMP agent sends a trap to the configured trap receiver(s).
Only one trap is sent for each 15-minute data collection period. ADSL port configuration
requires assigning an alarm profile, therefore you must configure the desired alarm profile prior
to configuring the ADSL port. A default profile exists with an index of 1. You cannot delete the
default profile.
You configure ADSL alarm profiles from the
::alarm=>
prompt. From the
::root=>
prompt, type the following command then press to display the
::alarm=>
prompt.
configuration adsl profile alarm
Adding ADSL Alarm Profiles
From the
::alarm=>
prompt, type the new command in the following format then press
to create a new ADSL alarm profile. The profile is automatically assigned the next
available index number in the ADSL alarm profile table.
new <ulof> <ulos> <ues> <dlof> <dlos> <des>
Parameters
<ulof>
Upstream loss of frame threshold. This threshold determines the acceptable number of
seconds in a 15-minute data collection period during which the frames lose sync on the
ADSL interface. In a normal environment with sufficient margin, a typical loss of frame
threshold value is 10. A value of
0 disables the alarm.
<ulos>
Local loss of signal threshold. The loss of signal threshold determines the acceptable
number of seconds in a 15-minute ADSL performance data collection period during which
the line power falls below the target margin threshold. In a normal environment with
sufficient margin, a typical loss of signal threshold value is 10. A value of
0 disables the
alarm.
<ues>
Local errored seconds threshold. This threshold is the acceptable number of seconds in a
15-minute data collection period during which errors occur on the ADSL interface that
prevent the payload from being corrected. In a normal environment with sufficient margin,
a typical errored seconds threshold value is 10. A value of
0 disables the alarm.
ENTER
ENTER