Adaptec MAN-00005-UG, Installation And User Manual

Page: 84 / 237

© 2003, Adaptec, Inc.
85
Note: A controller reset is required to make a change to this option take affect.
Host port speed: Sets a 1 or 2 Gigabits per second for Auto Negotiate speed for the selected host
ports.
Hard loop addressing: Enables hard loop IDs on a controller.
Note: A controller reset is required to make a change to this option take affect.
ID field: is displayed only if Hard Loop Addressing is enabled. It allows you to select a value
0-125.
8 Select IP settings
Figure 55 Figure 55 Controller Properties Dialog Box: IP Settings
Note: The IP Setting Tab is not shown if IP is not supported by the controller firmware.
All fields on this dialog support the Internet Protocol version 4. If an IP-configurable controller is not available in a slot,
the slot selections are not available. Modifying these slot fields may affect the ability of the Spheras Storage Director
Server to communicate with the controller.
If an IP configurable controller is discovered and an IP address has not yet been set for that controller, the status of the
controller is
partially discovered . The IP address may or may not be seen in the slot field. When a controller is partially
discovered, no other controller properties dialogs are available. You must enter valid information in at least one of the
slot fields and click
OK before the other dialogs are enabled. If communication fails, you must again try and enter valid
information in one of the slot fields.