Installation and Operation Manual
Chapter
4 Configuration
ACE-3105, ACE-3205 Ver. 5.2
Configuring for Operation 4-99
Setting the LDP Targeted Peers
You can define targeted remote peers with which ACE-3105, ACE-3205 should
attempt establishing LDP sessions.
³
To set the targeted peers:
•
From the LDP menu, select Targeted Peers.
The Targeted Peers menu is displayed.
ACE-3205 – RAD Data Communications
Configuration> Applications> MPLS> Signaling protocol> LDP > Targeted peers
1. Peer number ... (1)
Peer name ... (Peer-1)
IP address ... (192.168.238.10)
2. Targeted mode ... (Disable)
>
Please select item <1 to 2>
ESC-previous menu; !-main menu; &-exit
Figure
4-70. Targeted Peers Menu
Table
4-63. Targeted Peers Parameters
Parameter Description
Possible
Values
Peer number
ID of an existing (previously defined)
remote targeted peer. You can enter a
different number to display another peer's
details.
1–32
Peer name
Displays the name of the remote targeted
peer selected above
IP address
Displays the IP address of the remote
targeted peer selected above
0.0.0.0 –
255.255.255.255
(must match the IP of
the remote peer)
Targeted mode
Enables or disables the targeted peers
functionality. When enabled, ACE-3105,
ACE-3205 attempts to create a targeted
LDP session with the peer.
Enable
Disable
Default: Disable
Configuring the Tunnel MPLS Parameters
This section explains how to configure the PHP mode and the LSP tunnels. LSP
tunnels are configured separately in the ingress and egress directions.
³
To configure the PHP mode:
1.
Navigate to the Tunnel LSP menu (
)
