Chapter
4 Configuration
Installation and Operation Manual
4-58
Configuring for Operation
ACE-3105, ACE-3205 Ver. 5.2
Parameter Description
Possible
Values
IP translation
Enables translating the IP address of
Node B.
Note: IP translation cannot be enabled if:
•
The router interface is configured over
the Ethernet port used by the PPPoE.
•
The router interface is configured over
this PPPoE entity.
•
The translated IP address does not have
a route
•
The translated IP address does have a
route but is pointing to an Ethernet port,
which is either configured as a bridge
port, or has peers defined to it.
Enable
Disable
Default: Disable
Translated IP
address
The original IP address of the Node B, being
translated while receiving/transmitting
traffic.
Note:
•
This parameter only shows if IP
Translation is enabled.
•
The IP address cannot be changed on
the fly.
0.0.0.0 –
255.255.255.255
Default: 0.0.0.0
The PPPoE parameters can be changed dynamically (on-the-fly).
Binding the PPPoE Interface
To bind the interface to the PPPoE protocol, configure the following parameters:
ACE-3205 – RAD Data Communications
Configuration> Logical layer> PPPoE> Bind Interface
1. Interface type > (Ethernet)
2. Port/group number ... (1)
3. VPI ... (0)
4. VCI ... (32)
>
Please select item <1 to 16>
ESC-Previous menu; !-main menu; &-exit
Figure
4-45. PPPoE Menu – Bind Interface
Note
