Chapter
4 Configuration
Installation and Operation Manual
4-40
Configuring for Operation
ACE-3105, ACE-3205 Ver. 5.2
ACE-3205 – RAD Data Communications
Configuration> Physical layer> Port> Ethernet
1. Port number ... (1)
2. Port activation > (Enable)
3. Auto negotiation > (Enable)
4. Max capacity advertised > (100BaseT Full Duplex)
5. Default type > (100BaseT Full Duplex)
6. Rate limiter > (Disable)
7. Output rate (Mbps) > (100)
>
Please select item <1 to 6>
ESC-previous menu; !-main menu; &-exit
Figure
4-34. Ethernet Port Configuration Menu
Table
4-28. Ethernet Port Configuration Parameters
Parameter Description
Possible
Values
Port number
Select the Ethernet port that you want to
configure. For each selected port, different
parameters may be displayed and saved.
1, 2
Default: 1
Port activation
Enables/disables the Ethernet port in both
directions, RX and TX. When the port is
disabled, the TX and RX paths are disabled.
Log file events or traps are not sent from
this port upon physical layer events.
Note: Port 2 cannot be enabled if a PW of
(Type = ‘Basic CES PSN’) & (Sub type =
‘Clock recovery’) & Peer is routed via the
router interface over DSL VCL.
Enable
Disable
Default: Enable
Auto
negotiation
Status of the autonegotiation mode for the
selected port. Valid only when Port
activation is set on 'Enable'.
Enable
Disable
Default: Enable
Max capacity
advertised
Identifies the set of capabilities advertised
by the local autonegotiation entity.
Visible only if autonegotiation is enabled.
10BaseT Half Duplex
10BaseT Full Duplex
100BaseT Half Duplex
100BaseT Full Duplex
Default:
100BaseT Full Duplex
