32
Pressure and release in programming:
allows scrolling of folders
parameters (ST, CF, etc); allows it
scrolling through the list of parameters.
In the parameter modification phase
increases its value.
___________________________________________________
Pressure and release:
from main view allows
the display of the probe values
configured (temperatures / pressures)
in the upper display and the label
corresponding in the lower display.
___________________________________________________
Pressure and release
in programming:
allows scrolling of folders
parameters (ST, CF, etc); allows it
scrolling through the list of parameters.
___________________________________________________
When changing the parameter decreases its
value. Pressure and release:
allows you to turn on the machine (in chiller or
heat pump) or select the std-by mode.
Pressure and release:
allows you to turn on the machine
(in chiller or heat pump)
or select the std-by mode.
Pressure and release:
allows access to the function menu.
Pressure 3 seconds and release:
allows you to adjust the clock
in the models in which it is intended.
___________________________________________________
Pressure and release in programming:
lets go out from parameter modification.
___________________________________________________
Simultaneous pressure of the keys
for 3 seconds:
allows access to programming of the parameters.
Simultaneous pressure of the keys:
1. allows exit from
parameter programming.
2. contemporary pressure
prolonged keys allows
entry into manual defrost
___________________________________________________
Remote terminal
Regarding the use of the remote terminal (indications to the
display and the meaning of the keys) refer to the paragraphs
previous.
In air / air units, in case of terminal use remote equipped with
NTC probe (VICXS610), configuring par. CF35 = 2 the display
will show the ambient air temperature; this probe will be used by
the controller for thermoregulation. In case of failure of the
controller / remote terminal or error in the wiring, lack of
communication between the instrument and the remote terminal
will be indicated on the display with the message of error
"noL" (no link).
14.4
PARAMETER ACCESS
1 Press the SET and down arrow keys for a few seconds;
2 The icons flash and the upper display
displays "ALL" (generic group of parameters);
3 Scroll through the parameter groups with the keys and select
the group
containing the parameters to be modified; pressing the button
set allows access to the list of parameters contained
in the group. The lower display shows the parameter label
and the upper display shows the value.
14.5 DISPLAY AND MODIFY THE SET POINT
Pressing and releasing the SET key allows the
display of the set point.
The prolonged pressing of the SET key allows its modification:
1 Press the SET button for at least 3 seconds;
2 The set point will be displayed flashing;
3 To change the value, use the and keys
e
4
Save the new set point by pressing the SET or button
wait for the time out time to exit the program.
User interface
Summary of Contents for HUB RADIATOR PACK CF 3.0
Page 2: ...2...
