ABB FBIP-21 BACnet/IP, User Manual

Page: 34 / 74

BACnet access point Description Drive parameter
AV0 Estimated motor speed in RPM 01.01 Motor speed used
AV1 Estimated drive output frequency
in Hz 01.06 Output frequency
AV2 DC bus voltage 01.11 DC voltage
AV3 Calculated motor voltage in V AC 01.13 Output voltage
AV4 Measured (absolute) motor cur-
rent in A 01.07 Motor current
AV5 Motor torque in percent of the
nominal motor torque 01.10 Motor torque
AV6 Drive output power 01.14 Output power
AV7 Estimated drive temperature in
percent of fault limit 05.11 Inverter temperature
AV8 Cumulative energy usage of the
drive. This value can be reset. 01.57 Inverter kWh counter (reset-
table)
AV9 Amount of energy that has
passed through the drive (in
either direction) in full kilowat-
thours. Whenever the counter
rolls over, 01.19 Inverter MWh
counter is incremented. The min-
imum value is zero. 01.20 Inverter kWh counter
AV10 This object is the Process PID
feedback signal. 40.97 Process PID feedback %
AV11 This object is the Process PID
output signal’s deviation from its
setpoint. 40.99 Process PID deviation %
AV12 External PID feedback percentage
scaled -
AV13 This object is the External PID
output signal’s deviation from its
setpoint. -
AV15 Displays the motor temperature
as estimated by the internal mo-
tor thermal protection model 35.01 Motor estimated temperat-
ure
AV31 Motor speed in percent of the 01.03 Motor speed %
synchronous motor speed.
AV130 Current hour energy consump-
tion. This is the energy of the last
60 minutes (not necessarily con-
tinuous) the drive has been run-
ning, not the energy of a calendar
hour. The value is set to the value
before the power cycle when the
drive is again up and running. 01.50 Current hour kWh
34 Start-up