ABB FBIP-21 BACnet/IP, User Manual

Page: 32 / 74

For more information on scaling of analog outputs and inputs, see the firmware
manual.
BACnet access point Description Value Drive parameter
AO0 Analog output 1 con-
trolled by fieldbus AO1 data storage 13.12 AO1 source
AO1 Analog output 2 con-
trolled by fieldbus AO2 data storage 13.22 AO2 source
AO0 Minimum value of signal
selected by parameter
13.12 AO1 source 0.0 13.17 AO1 source min
AO0 Maximum value of signal
selected by parameter
13.12 AO1 source 100.0 13.18 AO1 source max
AO1 Minimum value of signal
selected by parameter
13.22 AO2 source 0.0 13.27 AO2 source min
AO1 Maximum value of signal
selected by parameter
13.22 AO2 source 100.0 13.28 AO2 source max
Data point connections
The BACnet access points in the above drive parameter connections are linked to the
following data points:
Description Drive parameter BACnet access point
Storage parameter for
AO1 13.91 AO1 data storage AO0
Storage parameter for
AO2 13.92 AO2 data storage AO1
￭
PID control
For PID control through BACnet/IP, configure the following drive parameters and set
the building controller supplied PID value(s) in the appropriate location:
BACnet access point Description Value Drive parameter
AV43 Feedback 1 source data
storage Feedback storage 40.08 Set 1 feedback 1
source
AV43 Feedback 2 source data
storage Feedback storage 40.09 Set 1 feedback 2
source
AV42 Setpoint 1 source data
storage Setpoint data storage 40.16 Set 1 setpoint 1
source
AV42 Setpoint 2 source data
storage Setpoint data storage 40.17 Set 1 setpoint 2
source
32 Start-up