ABB ACS260-04 Series, User Manual

Page: 63 / 98

Parameters 63
Read Only Status parameters
The user must be in the Long Parameter group to gain access to the Read only
status parameters.
In the Long Parameter Group when the user scrolls to parameter “ 0000 ” , pressing
will display “ 0104 ”, t he User can then scroll to the required Read only status
parameter (as listed in the table above). Pressing once more will then display the
value of that particular Read only status parameter.
For those parameters which have multiple values (e.g. software ID parameter 3301 ),
pressing the and keys will display the different values within that parameter.
Pressing returns to the next level up. If is then pressed again (without
pressing or ), the display changes to the next level up (main parameter level,
i.e. Parameter
“ 0000 ”).
The following table includes the descriptions of all Read Only status parameters.
Actual signals
No. Name/Value Description
01 OPERATING DATA Basic signals for monitoring the drive (read-only).
For selection of an actual signal to be displayed on the control panel,
see parameter
3405 DISPLAY SCALING SOURCE.
0102 Rotor Speed
(Estimated) In vector control mode, this parameter displays the estimated rotor
speed of the motor.
0104 Motor Current 8 most recent values prior to trip, updated every 250ms
0107 DC BUS VOLTAGE Displays the instantaneous DC Bus Voltage internally within the drive
in V DC. (0…1000V dc)
0109 APPLIED MOTOR
VOLTAGE Displays the instantaneous output voltage from the drive to the motor
V AC. (0…600V AC)
0110 INTERNAL
HEATSINK
TEMPERATURE
Temperature of heatsink in
°
C (-20 … 100 °C)
0111 SPEED REFERENCE
INPUT
Displayed in Hz if Parameter 9908 MOTOR RATED SPEED = 0,
otherwise displayed in RPM. (- 2008 … 2008)
0115 KWh/MWh METER Total number of KWh/MWh consumed by the drive.
0120 ANALOG INPUT 1
APPLIED SIGNAL
LEVEL Displays the signal level applied to analog input 1 (Terminal 6) in %
after scaling and offsets have been applied.
0121 ANALOG INPUT 2
APPLIED SIGNAL
LEVEL Displays the signal level applied to analog input 2 (Terminal 4) in %
after scaling and offsets have been applied.
0126 PI CONTROLLER
OUTPUT Displays the output level of the PI controller in %.
0140 HOURS RUN METER Not affected by resetting factory default parameters.
(0 to 99 999 hours)
0150 INTERNAL DRIVE
TEMPERATURE Actual internal ambient temperature in °C
ACS260-04.book Page 63 Thursday, December 24, 2020 4:33 PM