Parameters 47
PAR-A Parameter list
The following table describes the parameters that are visible in the “PAR-A” mode
(Advanced parameters).
Parameters in the Advanced parameter mode
Index
Name/Selection
Description
Def
2017
Maximum Current Limit
Defines the max current limit in vector control modes.
110 %
0.1…175.00
2105
DC Injection Speed
Sets the speed at which DC injection current is
applied during braking to Stop, allowing DC to be
injected before the drive reaches zero speed if
desired.
0.0
Hz/Rpm
0.0…
2008
2106
DC Injection Current
Sets the level of DC injection braking current applied
according to the conditions set in
2104
and
2105
.
20 %
0.0…
100.0
2301
Vector Mode Gain
Single Parameter for Vector speed loop tuning.
Affects P & I terms simultaneously. Not active when
9903
= 1.
50 %
0.0…
200.0
2605
Operating Mode Select
Provides a quick set up to configure key parameters
according to the intended application of the drive.
Parameters are preset according to the table.
2
0: Industrial Mode
Intended for general purpose applications.
1: Pump Mode
Intended for centrifugal pump applications.
2: Fan Mode
Intended for Fan applications.
9903
Motor Control Mode
Selects the motor control method.
2
0: Vector speed control
mode
1: V/f mode
2: PM motor vector speed
control
3: BLDC motor vector
speed control
9910
Motor parameter
Autotune
Drive measures the motor parameters for optimum
control and efficiency. Following completion of the
autotune.
0:
Disable
0: Disable
1: Enable
Drive immediately carries out a non-rotating autotune,
parameter
9910
MOTOR PARAMETER AUTO-TUNE
ENABLE returns to 0 when completed.
Setting
Application
Current Limit
(
2017
)
Torque Characteristic
(
2610 & 2611
)
Spin Start (
2101
)
0
General
150%
Constant
0 : Off
1
Pump
110%
Variable
0 : Off
2
Fan
110%
Variable
2 : On
ACS260-04.book Page 47 Thursday, December 24, 2020 4:33 PM
Summary of Contents for ACS260-04 Series
