1-8
To do...
Use the command...
Remarks
Enable CCM sending on a MEP
cfd cc service-instance
instance-id mep mep-id
enable
Required
Disabled by default
The relationship between the interval field value in the CCM messages, the interval between CCM
messages and the timeout time of the remote MEP is illustrated in
Table 1-2
.
Table 1-2
Relationship of the interval field value, the interval between CCM messages and the timeout
time of the remote MEP
The interval field value
The interval between CCM
messages
The timeout time of the
remote MEP
4
1 second
3.5 seconds
5
10 second
35 seconds
6
60 seconds
210 seconds
7 600
seconds
2100
seconds
On different devices, the MEPs belonging to the same MD and MA should be configured with the same
time interval for CCMs sending.
Configuring LB on MEPs
The LB function can verify the link state between two ends after CC detects a link fault.
Configuration Prerequisites
Before configuring this function, you should first complete the MEP and MIP configuration tasks.
Configuration Procedure
Follow these steps to configure LB on MEP:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enable LB
cfd loopback service-instance instance-id mep
mep-id
{
target-mep target-mep-id
|
target-mac
mac-address
} [
number loopback-number
]
Required
Disabled by default
Configuring LT on MEPs
LT can trace the path between the specified MEP and the target MEP, and can also locate link faults by
sending LT messages automatically. The two functions are implemented in the following way:
