3Com 4210G Series, Configuration Manual, Page: 9 / 1133

2-1
2
Features
The following sections provide an overview of the main features of each module supported by the
Switch 4210G.
Access Volume
Table 2-1
Features in Access volume
Features Description
Ethernet Port
This document describes:
z
Combo Port Configuration
z
Basic Ethernet Interface Configuration
z
Configuring Flow Control on an Ethernet Interface
z
Configuring the Suppression Time of Physical-Link-State Change on
an Ethernet Interface
z
Configuring Loopback Testing on an Ethernet Interface
z
Configuring a Port Group
z
Configuring an Auto-negotiation Transmission Rate
z
Configuring Storm Suppression
z
Setting the Interval for Collecting Ethernet Interface Statistics
z
Enabling Forwarding of Jumbo Frames
z
Enabling Loopback Detection on an Ethernet Interface
z
Configuring the MDI Mode for an Ethernet Interface
z
Testing the Cable on an Ethernet Interface
z
Configuring the Storm Constrain Function on an Ethernet Interface
Link aggregation
Link aggregation aggregates multiple physical Ethernet ports into one
logical link. This document describes:
z
Basic Concepts of Link Aggregation
z
Configuring a Static Aggregation Group
z
Configuring a Dynamic Aggregation Group
z
Configuring an Aggregate Interface
z
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Port Isolation
The port isolation feature allows you to isolate different ports within the
same VLAN. This document describes:
z
Introduction to Port Isolation
z
Configuring the Isolation Group
MSTP
MSTP is used to eliminate loops in a LAN. It is compatible with STP and
RSTP. This document describes:
z
Introduction to MSTP
z
Configuring MSTP