3Com 4210G Series, Configuration Manual, Page: 118 / 1133

5-8
Setting the LLDP Re-Initialization Delay
When LLDP operating mode changes on a port, the port initializes the protocol state machines after a
certain delay. By adjusting the LLDP re-initialization delay, you can avoid frequent initializations caused
by frequent LLDP operating mode changes on a port.
Follow these steps to set the LLDP re-initialization delay for ports:
To do… Use the command… Remarks
Enter system view
system-view
—
Set the LLDP re-initialization
delay
lldp timer reinit-delay delay
Optional
2 seconds by default
Enabling LLDP Polling
With LLDP polling enabled, a device checks for local configuration changes periodically. Upon
detecting a configuration change, the device sends LLDP frames to inform the neighboring devices of
the change.
Follow these steps to enable LLDP polling:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter
Ethernet
interface view
interface interface-type
interface-number
Enter Ethernet
interface view
or port group
view
Enter port
group view
port-group manual port-group-name
Required
Use either command.
Enable LLDP polling and set
the polling interval
lldp check-change-interval interval
Required
Disabled by default
Configuring the TLVs to Be Advertised
Follow these steps to configure the LLDPDU TLVs to be advertised out the specified port or ports:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter
Ethernet
interface view
interface interface-type interface-number
Enter
Ethernet
interface
view or
port
group
view
Enter port
group view
port-group manual port-group-name
Required
Use either command.