3Com 4210G Series, Configuration Manual, Page: 877 / 1133

9-14
z
When you configure the password for switching user privilege level with the
super password
command, the user privilege level is 3 if no user privilege level is specified.
z
The password for switching user privilege level can be displayed in both cipher text and simple
text. You are recommended to adopt the former as the latter is easily cracked.
Modifying command level
All the commands in a view are defaulted to different levels, as shown in Table 9-3 . The administrator
can modify the command level based on users’ needs to make users of a lower level use commands
with a higher level or improve device security.
Follow these steps to modify the command level:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the command level
in a specified view
command-privilege level
level view view
command
Required
Refer to
Table 9-3 for the
default settings.
You are recommended to use the default command level or modify the command level under the
guidance of professional staff; otherwise, the change of command level may bring inconvenience to
your maintenance and operation, or even potential security problem.
Displaying and Maintaining Basic Configurations
To do… Use the command… Remarks
Display information on system version
display version
Display information on the system clock
display clock
Display defined command aliases and the
corresponding commands
display command-alias
Display information on terminal users
display users
[
all
]
Display the valid configuration under
current view
display this
[
by-linenum
]
Display clipboard information
display clipboard
Display and save statistics of each
module’s running status
display diagnostic-information
Available in
any view