Artisoft LANtastic 6.0
29
6
Choose the appropriate options for your network environment and complete the
installation.
7
Refer to the IBM documentation if you have questions about these menus.
8
Copy a:\NDIS2\EL3C574.DOS from the Installation Disk to C:\NET.
9
After completing the installation, exclude the CIS memory address range for the
LAN card by editing the CONFIG.SYS file.
10
Reboot the PC.
Artisoft LANtastic 6.0
To install the 3Com NDIS driver (EL3C574.DOS) for Artisoft LANtastic 6.0, follow
these steps. You can install the driver from either the DOS prompt or Windows.
DOS Prompt
1
Insert Artisoft’s LANtastic Disk 1 in the floppy disk drive.
2
Type a:install and press Enter
.
Windows launches and starts the installation of LANtastic.
3
Go to step 5 under the following “Windows” procedure and continue with the
remaining steps.
Windows
1
Launch Windows, if it is not already opened.
2
Put the Installation Disk in the floppy drive.
3
Select
Run
from the
File
menu.
4
Type a:\install and press Enter
.
5
Follow the instructions and enter the required information.
6
Select
NDIS Support for Network Adapters
in the Select
Network Adapter
window.
7
When prompted, remove the LANtastic disk, insert the
LAN Installation Disk
and
press Enter.
The NDIS driver is copied to your hard drive from the LAN Installation Disk.
8
When prompted, reinsert the LANtastic Disk 1 in the floppy drive.
9
Follow the instructions and enter the required information about your PC name
and configuration.
DEC PATHWORKS
The DEC PATHWORKS for DOS/Windows software must be installed on the hard
drive. Refer to the DEC documentation for installation instructions if the software
has not been installed and for templates and options.
Run the AutoLink program on the Installation Disk if you are installing DEC
PATHWORKS with Retail NDIS or NDIS with ODI drivers. To install DEC
PATHWORKS for DOS/Windows 5.1, follow these steps:
1
Go to the drive where the PATHWORKS software is installed.
2
Go to the PCAPP directory.
3
Execute PWSETUP.
