4
S
ETUP
FOR
W
INDOWS
NT
Inserting the PC Card
and Running the
Installation
1
Either print this page or write down the following seven steps.
2
Log out of Windows and turn the computer off.
3
Insert the PC Card into the PC Card slot.
4
Connect the PC Card to the network as shown in Chapter 5
5
Turn your computer on and log in to Windows.
6
Insert the CD into the CD-ROM slot. The auto-start feature will start the PC Card
installation. If auto-start is disabled on your computer, click Start>Run and type
d:\setup.exe
(where d: is your CD-ROM drive).
7
Select
Install PC Card
. This page will appear.
8
Select the appropriate subsection and follow the instructions to install the network
drivers.
Installation Using
Softex Software
Use the following procedures if the Softex PC Card Controller for Windows NT 4.0
is installed on your system. If the Softex software is not installed, use the
procedures for “Installation Using Point Enabler” on page 14.
For the following procedures:
■
The computer must be running Windows NT 4.0.
■
The Softex PC Card Controller for Windows NT 4.0 must be installed.
■
Windows NT Service Pack 3 or later must be installed.
If you are reinstalling the card, make sure you have completed the procedures
for “Uninstalling the Card” on page 16. For Windows NT 4.0 installation, you
must have Service Pack 3 or later installed on your computer. After installation,
reinstall the Service Pack software to update NT network files and eliminate
error messages in the Event Viewer. Contact your Network Administrator or
Microsoft if you do not have the current Service Pack.
