2N Lift8, User Manual

Page: 206 / 377

2N TELEKOMUNIKACE a.s., www.2n.cz 206/377
System Completeness Check Enable
Use the RESET button to set the function.
Press and hold the button until all the LEDs light up red. Release the button and wait
until the INTERNAL BUS LED lights up yellow. Now push the button shortly to make
the system check all the audio units (cabin, Fireman) for proper connection and
function.
Audio Unit Audio Test
Use parameter 993 to enable the audio test for audio units. The selected audio units
(cabin, Fireman) are tested after a check call . If all the audio units are OK, the next
check call will be made. If an audio error is detected in one or more audio units, the
next check call will not be made.
The INTERNAL BUS LED flashes red to indicate an audio test failure.
Note
An audio test is considered unsuccessful if it fails three times.
The test is carried out three times in 1-hour intervals.
Audio Error Event
In version 2.3 and higher an event can inform of an unsuccessful audio test. Use the 2N
Events menu for audio error configuration. When an audio test error is Service Tool
®
detected, any of the following events is executed.
The following options are available:
IO module output activation
IO module output deactivation
Send SMS - set the phone number and text (for GSM/UMTS module only)
Send system SMS - set the phone number (for GSM/UMTS module only)
Operational call - this call is set up to the number defined in parameters 081-088
(Operational call) and uses CPC antenna, CPC KONE or P100 for transmissions
Caution
The event is not executed until the audio test fails three times.
SMS can be sent only if the GSM/UMTS module is installed.