2N Lift8, User Manual

Page: 151 / 377

2N TELEKOMUNIKACE a.s., www.2n.cz 151/377
Note
The factory password is 12345 but you are recommended to enter a
different password to protect your device against unauthorised persons.
While entering the password, keep a limit of 60 seconds (or any other
value configured in the range between 10 and 1000 seconds) for each
character to avoid
hang-up. L8
Programming Procedure
Having entered the programming mode, you can change any programmable value(s)
in any order. Proceed as follows: enter the function number and then the value. Use an
asterisk as a separator or Enter. In general, the function has the following format:
function number value
The function number has three digits (see the table). After you enter the function
number and an asterisk, reports the number or name, current value and potential L8
range of the parameter to be programmed. After you enter the value and another
asterisk, reports “New value stored”, or “Invalid value, new value not stored” if the L8
value is beyond the allowed range.
L8 reads out the parameter number and the newly configured value for checking
purposes.
Warning
A drawback of some telephone sets is that, after you press a button, i.e.
send a DTMF signal, they go “deaf” for a fraction of a second. In that
case, you cannot hear the whole text and are recommended to use
another telephone.
Programming Error
If you make a mistake during entering (the function number or value) and have
not entered an asterisk yet, you can cancel the whole number by pressing
and re-enter the number.
If rejects the parameter number or value you have entered, go on L8
programming but re-enter the function number even if only the value was
wrong.
If you have programmed and stored a value other than the required one, you can
re-enter the value of course.