Modulate Pad and Effect Parameters
Bitbox mk2 allows you to modify the values of pad and
effect parameters in real time using external signals. For
example, you can use MIDI Velocity to control the Level
of a pad, or EXT1 to adjust the filter. You can use a
Trigger or CV input to control which slice of a Slicer pad
will be played on the next note event. The parameter
tables in this document indicate which parameters can be
used as modulation targets. On the parameter screens
you can easily identify the modulation targets by the
three black boxes that appear below them. You can use
up to three different signal sources to modulate each
parameter. The same signal can be used to modulate
multiple parameters.
To Apply CV or MIDI Modulation:
1.
From the Pads screen, touch the pad you want
to modulate. If you want to modulate an effect
parameter, go to the FX screen and touch the
effect (FX1 or FX2) you want to modulate.
2.
Press INFO once or twice to display the
Parameters screen. If needed, touch the page
tab for the parameter you want to modulate.
3.
Touch one of the three black boxes below the
parameter to display the Modulation
Parameters screen.
4.
Use the top left knob to select a value for the
Source parameter. This parameter specifies
which signal will be used to control this
parameter. Available sources are shown in the
table on the next page.
5.
Use the top right knob to select the Amount of
modulation that will be applied. This is used to
increase or decrease the amount of impact the
modulation will have on this parameter. The
Amount does not apply to all modulation
targets. An amount of 0.0% (the default)
means the modulation will not impact this
parameter.
Parameters screen with
Modulation Targets
Modulation Parameters
Screen
Copyright 1010music LLC 2020
Page 66 of 82
Bitbox MK2 1.0.8 User Manual
