39
5.2.10 Deleting the programmes
• Press
and browse the menu using the
buttons.
• Press
to confirm.
•
The programmes will be reset to 00:00.
5.2.11 Use with a filtration control panel
In this configuration, the filtration control panel powers the appliance on and off.
• This connection mode is not recommended since the appliance has its own internal timers.
•
In order to be controlled by a filtration control panel, the appliance's programmes must be reset, see
"5.2.10 Deleting the programmes".
•
Once connected to the filtration control panel, switch the appliance off and on again.
5.2.12 Slave mode
"Slave"
mode transfers control over the chlorination function to an external controller. The external controller must
be
connected to the connection point
on the low-voltage circuit, see
“2.5 I Electrical connections”.
"Boost"
and
"Low"
modes can still be managed by the controller. However, the appliance's programmes are deactivated.
Chlorine production is maintained at 100%.
•
Connect the external controller to the slave connection point on the low-voltage circuit, see
“2.5 I Electrical
connections”.
• Press
and
browse the menu using the
buttons.
Press
to confirm.
• Press
to exit.
EN
