ZIEHL-ABEGG Fcontrol FTET4AHMQ, Руководство по эксплуатации

Страница: 19 / 46

7.7 IO Setup = Assignment of inputs and outputs
IO Setup
P
↓
↑
▼ + ▲
=
|
Esc
|
Outdoor temperature
Outdoor temperature
OFF
= No measurement of the supply air temperature.
If ON = measurement of supply air temperature active. Sensor on “ E2 ” is taken into
consideration for the temperature alarm message (Adjustable alarm di ff erential).
K1 Invert.
K1 Invert.
Inverting the “ K1 fault indicator relay ”
OFF = Relay “ K1 ” releases in cases of malfunctions, i.e., terminals 11 - 12 are bridged
(factory setting) .
ON = Relay “ K1 ” connects in cases of malfunctions, i.e., terminals 11 - 14 are bridged.
K2 Invert.
K2 Invert.
Inverting the heating relay “ K2 ”
OFF = Relay “ K2 ” attracts so that the heating is active, i.e., terminals 21 - 24 are
bridged (factory setting) .
ON = Relay “ K2 ” releases so that the heating is active, i.e., terminals 21 - 22 are
bridged.
A1 Inverting
A1 Inverting
Inverting “ A1 ” Shutter
OFF = 0 V...10 V
ON = 10 V...0 V (factory setting)
Attention is advised when operating with the output characteristic curve without invert-
ing!
A1 output curve
A1 output curve
OFF
= (factory setting)
ON = programming of curve active, to see the following characteristic curve points.
A2 Inverting
A2 Inverting
Inverting “ A2 ” (depending on the “ heating mode ” for the sequence controller or heating)
OFF = 0 V...10 V (factory setting)
ON = 10 V...0 V
Attention is advised when operating with the output characteristic curve without invert-
ing!
A2 output curve
A2 output curve
OFF
= (factory setting)
ON = programming of curve active, to see the following characteristic curve points.
Output curve P0
It is possible to operate with non-linear output characteristic curves for the actuator
outputs.
The curve that is intended to be operated is de
fi ned by 6 points (these are then the
same for all connected characteristic curves).
Each point can be set from 0 - 100 %. That means an inversion made in this manner is
also possible.
Operating Instructions Fcontrol – model series FTET4/6/10AHMQ The Installation menu
L-BAL-E094-GB 2022/47 Index 007 Part.-No.
19/46