ZIEHL-ABEGG Econtrol EXDM, Инструкция по эксплуатации

Страница: 49 / 86

9.9 Controller Setup
9.9.1 Menu overview Controller Setup
Controller Setup
Controller Setup
Parameter
Factory setting Mode
User
Setting
1.01 2.01 ... 2.05 , 3.01 ... 3.04 4.01 ... 4.03 , 5.01 ... 5.02 , 6.01
PIN Protection
OFF
Set protection
OFF
Save User Setup
OFF
Alarm sensors 0 OFF
Limit
- - - -
Msco. 0 OFF
Group 2 ON value
- - - -
nmin at Group2
- - - -
Val>Set=n+
0 ON OFF
Type of control
0 P PID
KP
0 50 % 50 %
KI
0 50 % 50 %
KD
0 50 % 50 %
TI
0 0 % 0 %
- - - - = display as long as no allocation has been carried out
0 = Function not available
9.9.2 PIN protection activate, PIN0010
PIN Protection
The adjustments for the installation in the service level can be protected
against unintentional modi  cations. To do this, activate the “ PIN protection ” =
“ ON ” .
In order to simplify the initial start-up operation, the service level in the factory
setting is free = “ OFF ” i.e. accessible without PIN 0010 .
Information
After installation of the device has been carried out, “ PIN-Protection ” should be activated = “ ON ”
9.9.3 Set protection activate, PIN 1234
Set protection
The “ Settings ” menu for the user ’ s basic settings (Setpoint, default value, min,
max ..) are freely accessible when using the factory settings (i.e. without
“ PIN ” ).
If necessary, these can also be protected against unauthorized modi  cations
by using a “ PIN 1234 ” . For this, the settings protection must be programmed
to “ ON ” . The settings menu is then no longer visible without inputting a PIN!
Function only in combination with activated PIN-Protection!
Operating Instruction Econtrol – model series EXDM Programming
L-BAL-E008-GB 0945 Index 005 Part.-No. 00156742-GB
48/85