ZeroClamp NP90, Инструкция по сборке и обслуживанию

Страница: 9 / 52

Safety
ZeroClamp zero point clamping system
– manual
9
Caution!
The zero point clamping system only operates reliably when the
clamp bolt lies flat and straight on the chuck. Even minor
contaminants between the supporting surfaces or if they are slightly
tilted will affect the proper functioning of the system. During the
processing the clamping pot must be covered by the pallet,
workpiece or of the fixture, if a controlled chip transport cannot be
ensured.
Otherwise the clamping pot can be covered partly.
Inaccuracy of the surfaces caused by wear will also prevent that
the correct clamping acts on the part.
Be sure to clean the supporting surfaces between clamp bolt and
chuck thoroughly every time before you clamp a new part!
Ensure an exact concentric alignment of clamp bolt and chuck!
Check the clamping force of the zero point clamping system on a
regular basis using the withdrawal force tester!
Operate the zero point clamping system no longer than 1,000,000
clamping cycles!
Caution!
When operating the zero point clamping system the skin of your
fingers can get caught between the clamping elements.
Do not reach inside the clamp bolt support!
Caution!
Inadverted operating of the zero point clamping system can
lead to an unintended releasing of the clamping mechanism.
Disconnect the zero point clamping system from the
compressed air supply prior to any assembly, adjustment,
maintenance or refitting works!
Secure the zero point clamping system against unintended
releasing using appropriate safety equipment for the compressed
air supply!