ZeroClamp NP90, Инструкция по сборке и обслуживанию

Страница: 27 / 52

Assembly
ZeroClamp zero point clamping system
– manual
27
Drilling of clamp bolt bores
Please note:
The inside micrometer may not exceed the max. tolerance of 0.01 mm. The
clamping system can compensate inside micrometer errors of up to 0.1 mm
(between 2 clamping points upon expansion of the palette/workpiece). The
clamp bolts are two-part design. The thread adapter is hand-tightened.
Art.
No.: Name Fit C D in
Alu
m. D in steel Recommended
installation
dimensions
(A/B) Recommended
Tightening
torque (Nm)
10004 18M16 18 k6 M16 18H7 18+0,02/+0,03 6 mm / 24 mm 35
10005 16M8 16 k6 M8 16H7 16+0,02/+0,03 6 mm / 24 mm 17
10006 16M10 16 k6 M10 16H7 16+0,02/+0,03 6 mm / 24 mm 35
10098 18M12 18 k6 M12 18H7 18+0,02/+0,03 6 mm / 24 mm 35
10416 12M10 12 k6 M10 12H7 12+0,02/+0,03 6 mm / 24 mm 35
11945 14M12/90 14 k6 M12 14H7 14+0,02/+0,03 6 mm / 21 mm 35
15267 12M10/90 12 k6 M10 12H7 12+0,02/+0,03 6 mm / 21 mm 35
11959 30M24/190 30 k6 M24 30H7 30+0,02/+0,03 7 mm / 38 mm 35
19854 12M10/138 12 k6 M10 12H7 12+0,02/+0,03 6 mm / 24 mm 35
19984 25M16/138 25 k6 M16 25H7 25+0,02/+0,03 6 mm / 31 mm 35
20178 18M12/138 18 k6 M12 18H7 18+0,02/+0,03 6 mm / 26 mm 35
20298 18M16/138 18 k6 M16 18H7 18+0,02/+0,03 6 mm / 24 mm 35