38
You may have to gently bend the pots and toggle switches a bit to get them all to slide in
(13). Keep working it until all three LEDs are protruding through the chassis (14).
13
14
b. Place a washer and a nut on each of the seven pots (15,16,17). Tighten the nuts down with
a 10mm socket, or a snub-nose pliers (18).
15
16
17
18
c. Thread a nut onto each of the toggle switches (19). Use an 8mm socket to very gently tighten
these down – but no more than finger tight (20)! Do not over-tighten these; you could actually
pull the threaded shaft out of the switch body!
19
20
