30
13. Audio Jacks (J1, J2): Install the 1/4” jacks into J1 and J2 (94). Make sure the bottoms of the
jacks are flat against the face of the PCB. Solder the pins (95-97).
94
95
96
97
14. Hookup Wires: The 5-conductor ribbon wire needs to be split into three pieces: two 2-wire
pieces and one 1-wire piece. Slit the wires at one end with your knife, and pull them apart
(98,99). Next, split the 2-wire pairs about ¼” (6mm) on each end (100). Now strip off about
1/8” (3mm) of insulation from each end of all five wires (101,102).
98
99
100
101
