Zelmer CK1000, Руководство пользователя

Страница: 29 / 29

31
GW17-060_v01
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in adv
Troubleshooting
Problem
Possible Cause Solution
The start switch will not stay in the on
position.
Your Hot Cup has not reset itself after the
boiling cycle.
Your Hot Cup is still too hot after the last
boil cycle. Wait a few seconds for it to cool
slightly before trying again.
The water tank does not illuminate and your
Hot Cup does not dispense boiling water.
Your Hot Cup is not plugged in.
Your Hot Cup is not positioned correctly
on its power base.
The fuse has blown.
Your Hot Cup has boiled dry.
Check your Hot Cup is plugged in and
switch on at the supply socket.
Check that the dispensing nozzle is
positioned centrally over the drip tray
Check the fuse in the plug.
Allow your Hot Cup to cool down
completely then reill it with water.
Your Hot Cup does not dispense a full cup
of water.
Your Hot Cup has excessive scale.
The dispensing control may be set too
low.
Descale your Hot Cup.
Adjust the dispensing control.
Your Hot Cup produces excess steam but
does not dispense boiling water.
The water level has dropped below the
MIN level.
Your Hot Cup has excessive scale.
Fill with water between the MIN and MAX
markings then restart the boil cycle.
Descale your Hot Cup.
Your Hot Cup makes a noise and there
is a ‘clunk’ sound after water has been
dispensed.
This is the sound of the internal valve
operating after the boil cycle inishes.
This is normal operation.
Water drips from the dispensing nozzle after
the boil cycle has inished.
There is a residual amount of water left
inside your Hot Cup after the boil cycle.
This is normal operation.
Steam comes out from the behind the start
button and behind the dispensing nozzle.
Steam is being vented in a controlled
manner through designed vents.
This is normal operation.
The water reservoir is getting hot. Hot water is being returned to the water
reservoir.
This is normal operation.
Your Hot Cup immediately turns itself on
when it is placed on the power base.
Your Hot Cup is already switched on. Press the stop button.
Ecology – environment protection
Each user can protect the natural environment.
It is neither dificult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to particular disposal
centre, because of the dangerous elements of this appliance,
which can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!