Page – 70/139
AFFZP0BB – ACE3 – User Manual
TESTER (Supervisor)
Parameter
Unit of measure
(resolution)
Description
B3 POT#5
(A)
Volt (0.01V)
Voltage of analog input B3.
CTRAP THRESOLD
(A)
Volt (0.01 V)
Threshold voltage of the hardware overcurrent.
WARNING SYSTEM
(CO)
-
In case of warning it shows the correspondent warning
code.
7.4 Set-up procedure for traction inverter
This section describes the basic set-up procedure for the ACE3 inverter in traction
configuration. If you need to replicate the same set of settings on different
controllers, use the SAVE and RESTORE sequence (see chapter 8); otherwise go
down the following sequence.
-
In ADJUSTMENT, set BATTERY VOLTAGE according to your set-up (see
paragraph 7.2.3).
-
Check the wiring and that all commands are functioning. Use the TESTER
function to have real-time feedback about their state.
-
Perform the accelerator acquisition using the PROGRAM VACC procedure
(see paragraph 8.1).
-
Set the maximum current for traction and braking in MAX. CURRENT TRA
and MAX. CURRENT BRK (see paragraph 7.2.1).
-
Set the motor-related parameters. It is suggested to discuss them with Zapi
technicians.
-
Set SET MOT.TEMPERAT according to the type of the motor thermal
sensor adopted.
-
Set the acceleration delay (ACCEL MODULATION and ACCEL DELAY
parameters). Test the behavior in both directions.
-
Set the FREQUENCY CREEP starting from 0.3 Hz. The machine should
just move when the drive request is active. Increase the level accordingly.
-
Set SPEED REDUCTION as required by your specifications.
-
Set the other performance-related parameters such as
RELEASE BRAKING, INVERSION BRAKING, DECELERATION BRAKING,
PEDAL BRAKING, SPEED LIMIT BRAKING, MAX SPEED FORW,
MAX SPEED BACK.
-
Make the choice for the truck behavior on a slope (STOP ON RAMP and
AUXILIARY TIME parameters).
-
Test the truck in all operative conditions (with and without load, on flat and
on ramp, etc.).
At the end of your modifications, re-cycle the key switch to make them effective.
Содержание ACE3
Страница 14: ...Page 14 139 AFFZP0BB ACE3 User Manual 3 2 Connection drawing ACE3 Traction Standard...
Страница 15: ...AFFZP0BB ACE3 User Manual Page 15 139 3 3 Connection drawing ACE3 Traction Premium...
Страница 16: ...Page 16 139 AFFZP0BB ACE3 User Manual 3 4 Connection drawing ACE3 Pump Standard...
Страница 17: ...AFFZP0BB ACE3 User Manual Page 17 139 3 5 Connection drawing ACE3 Pump Premium...
