AFFZP0BB – ACE3 – User Manual
Page – 55/139
ADJUSTMENT
Parameter
Allowable range
Description
MAX ANGLE RIGHT
(T,TM)
0° ÷ 90°
(by steps of 1°)
This parameter defines the maximum steering-wheel angle
while turning right.
MAX ANGLE LEFT
(T,TM)
0° ÷ 90°
(by steps of 1°)
This parameter defines the maximum steering-wheel angle
while turning left.
STEER DEAD ANGLE
(T, TM)
1° ÷ 50°
(by steps of 1°)
This parameter defines the maximum steering-wheel angle up
to which the permitted traction speed is 100%.
See paragraph 8.7
STEER ANGLE 1
(T, TM)
1° ÷ 90°
(by steps of 1°)
This parameter defines the steering-wheel angle at which
traction speed is reduced to the value imposed by CURVE
SPEED 1.
For steering-wheel angles between STEER DEAD ANGLE and
STEER ANGLE 1 traction speed is reduced linearly from 100%
to CURVE SPEED 1.
See paragraph 8.7
STEER ANGLE 2
(T, TM)
1° ÷ 90°
(by steps of 1°)
This parameter defines the steering-wheel angle beyond which
traction speed is reduced to CURVE CUTBACK.
For steering-wheel angles between STEER ANGLE1 and
STEER ANGLE 2 traction speed is reduced linearly from
CURVE SPEED 1 to CURVE CUTBACK.
See paragraph 8.7
SPEED FACTOR
(T, TM, CO)
0 ÷ 255
This parameter defines the coefficient used for evaluating the
truck speed (in km/h) from the motor frequency (in Hz),
according to the following formula:
⁄
10 ∙
SPEED ON MDI
(T, TM, CO)
OFF, ON
This parameter enables or disables the speed visualization on
MDI display:
ON =
MDI shows traction speed when the truck is moving.
In steady-state condition the speed indication is replaced
by the hour-meter indication.
OFF =
Standard MDI functionality.
LOAD HM FROM MDI
(T, TM, P, CO)
OFF, ON
This parameter enables or disables the transfer of the hour-
meter to a MDI unit.
OFF =
controller hour meter is not transferred and
recorded on the MDI hour meter.
ON =
controller hour meter is transferred and recorded on
the MDI hour meter (connected via the Serial Link).
CHECK UP DONE
(T, TM, P, CO)
OFF, ON
In order to cancel the CHECK UP NEEDED warning, set this
parameter ON after the required maintenance service.
Содержание ACE3
Страница 14: ...Page 14 139 AFFZP0BB ACE3 User Manual 3 2 Connection drawing ACE3 Traction Standard...
Страница 15: ...AFFZP0BB ACE3 User Manual Page 15 139 3 3 Connection drawing ACE3 Traction Premium...
Страница 16: ...Page 16 139 AFFZP0BB ACE3 User Manual 3 4 Connection drawing ACE3 Pump Standard...
Страница 17: ...AFFZP0BB ACE3 User Manual Page 17 139 3 5 Connection drawing ACE3 Pump Premium...