Yamaha XSR900 2022, Руководство по обслуживанию

Страница: 71 / 726

2-42
CABLE ROUTING
1. Throttle body
2. Cylinder head breather hose
3. Canister purge hose (purge cut valve sole-
noid to hose joint)
A. 5–7 mm (0.20–0.28 in) (3 places)
B. Insert the cylinder head breather hose until it
reaches the rounded end of the pipe. Install
the cylinder head breather hose with the yel-
low paint mark facing the left. Install the clip
with its end facing the left.
C. Yellow paint mark
D. 1–3 mm (0.04–0.12 in)
E. Insert the cylinder head breather hose until it
reaches the rounded end of the pipe. Install
the cylinder head breather hose with the
white paint mark facing the right. Install the
clip with its end facing the right.
F. White paint mark
G. 123
°
H. 105
°
I. 10
°
J. Install the canister purge hose completely
onto the purge cut valve solenoid.
K. Point the ends of the hose clamp upward.
L. Face the bolt head to the position as shown
in the illustration.
M. Point the ends of the hose clamp forward.
N. Install the canister purge hose completely
onto the hose joint.
O. Hose until it butts against the throttle body.
P. Point the ends of the hose clamp to the left.
Q. Point the ends of the hose clamp to the right.