Yamaha RX10RTL, Дополнительное сервисное руководство

Страница: 149 / 355

FI
Diagnostic mode table
Switch the meter display from the regular mode to the diagnosis mode. To switch the display, refer to
“DIAGNOSTIC MODE”.
NOTE:
• Check the intake air temperature and coolant temperature as close as possible to the intake air
temperature sensor and the coolant temperature sensor respectively.
• If it is not possible to check it with an atmospheric pressure gauge, judge it by using 101.3 kPa as
the standard.
• If it is not possible to check the intake air temperature, use the ambient temperature as reference.
Diagnostic
code
Item Description of action
Data displayed on meter
(reference value)
01
Throttle angle Displays the throttle angle.
• Check with throttle fully closed.
• Check with throttle fully open. 0 ~ 125 degrees
• Fully closed position (15 ~ 18)
• Fully open position (95 ~ 100)
02
Atmospheric pressure Displays the atmospheric pressure.
* Use an atmospheric pressure gauge to check the atmospheric
pressure.
Compare it to the value
displayed on the meter.
03
Intake air pressure Displays the intake air pressure.
Engine stop switch is on.
* Generate the pressure difference by cranking the engine with
the starter, without actually starting the engine.
• Not cranking-atmospheric
pressure
• Cranking-intake air pressure It
changes at the value whitch is
smaller than in the
atomospheric pressure.
05
Intake temperature Displays the intake air temperature.
* Check the temperature in the air cleaner case. Compare it to the value
displayed on the meter.
(min–30 [°C])
06
Coolant temperature Displays the coolant temperature.
* Check the temperature of the coolant. Compare it to the value
displayed on the meter.
(min–30 [°C])
07
Vehicle speed pulse Displays the accumulation of the vehicle pulses that are
generated when the tire is spun. (0 ~ 999; resets to 0 after 999)
OK if the numbers appear on
the meter.
09
Fuel system voltage
(battery voltage) Displays the fuel system voltage (battery voltage).
Engine stop switch is on. 0 ~ 18.7 V
Normally, approximately 12.0 V
24
Throttle switch The meter displays the following items: During the throttle switch
ON (throttle open): ON
During the throttle switch OFF (throttle close): OFF –
26
Grip warmer drive Drive the grip warmer when 1 second has passed after the grip
warmer down side switch is changed from OFF to ON. However,
if the input of grip warmer down side switch (Grip warmer down
side switch: from OFF to ON) changed before the operation as
mentioned above is finished, stop the driving operation and start
the operation newly. Light the engine warning lamp while the
grip warmer down side switch is turned ON. When it is moved to
other code, the operation as mentioned above should be
stopped immediately. The operation mentioned above is
repeated every time the grip warmer down side switch is
changed from OFF to ON. –
27
Thumb warmer drive Drive the grip warmer when 1 second has passed after the grip
warmer down side switch is changed from OFF to ON. However,
if the input of grip warmer down side switch (Grip warmer down
side switch: from OFF to ON) changed before the operation as
mentioned above is finished, stop the driving operation and start
the operation newly. Light the engine warning lamp while the
grip warmer down side switch is turned ON. When it is moved to
other code, the operation as mentioned above should be
stopped immediately. The operation mentioned above is
repeated every time the grip warmer down side switch is
changed from OFF to ON. –
FUEL INJECTION SYSTEM
68