Yaesu FTDX-9000MP, Руководство по эксплуатации

Страница: 6 / 180

Page 4 FT
DX
9000MP O
PERATION
M
ANUAL
1. Connecting AC Power
There are two power switches on this transceiver, one each on the rear and front panels. If the rear panel’s Power switch is
not turned on, the front panel Power switch will not function.
U
Push the Power switch on the
FPS-9000H to the [ I ] position
to apply power from the power
supply to the transceiver’s
OCXO (Reference Crystal Oven)
and to enable the front panel
power switch.
U
Press and hold in the front panel
Power switch for two seconds to
turn the transceiver on.
N N N N N
O O
O O
OTE TE
TE TE
TE
The self-check function of the CPU inside the ra-
dio will begin.
If the optional RF μ -Tuning Unit is installed, the
μ -Tuning circuitry will receive the data from the
CPU, and it will perform its own self-check, and
will preset itself to the proper settings for the cur-
rent operating frequency. While the
μ -Tuning cir-
cuitry is obtaining the data, the drive mechanism
will move from one end of its range to the other
end (fast), and this will cause a temporary “motor”
noise that can be heard; this, does not represent
any trouble or problem.
When the radio is turned on for the first time, it
takes about 50 seconds (from turning the radio on
to completing the self-check) until the radio be-
comes ready to use; however, from the next time
you turn it on, it will take around 10 seconds until
the transceiver is ready for full operation.
2. Configuring Your FT
DX
9000MP Using the Menu
The FT
DX
9000MP is configured, at the factory, with its various functions set up in a manner typical for most operation.
Via the “Menu” system, you may change these settings to match the way you want your transceiver to operate.
Menu programming is enabled by pressing the [ MNU
]
(Menu) key momentarily. You may then rotate the [ Main
Tuning Dial
] knob to display the desired Menu item, in
the menu list, on the LCD display. Each of the settings can
be changed or customized via the [
CLAR/VFO-B
] knob,
as you like, in this mode.
Once you have made a change to the configuration of a
Menu item or items, you must press
and hold in the [
MNU
]
(Menu) key for two seconds to save the new settings and
exit to normal operation.
If you wish to cancel a change to a Menu item or items,
just press the [
MNU
] key momentarily. If you do not press
and hold in the [
MNU
] key in for two seconds, any changes
you have made will not be saved.
[MNU] Key
[CLAR/VFO-B] Knob [Main Tuning Dial] Knob
Å Menu Item
Å Menu Setting
LCD Display
BBBBB
EFORE EFORE
EFORE EFORE
EFORE
Y Y Y Y Y
OU OU
OU OU
OU
B B B B B
EGIN EGIN
EGIN EGIN
EGIN
. . . . . .
. . . . . .
. . .