Yaesu FTDX-9000MP, Руководство по эксплуатации

Страница: 128 / 180

Page 126 FT
DX
9000MP O
PERATION
M
ANUAL
MMMMM
EMOR EMOR
EMOR EMOR
EMORYYYYY
G G G G G
RRRRROUPS OUPS
OUPS OUPS
OUPS
M
EMORY
G
ROUP
A
SSIGNMENT
1. Press the [
MNU
] key to enter the Menu mode.
2. Rotate the [ MAIN Tuning Dial
] knob to select Menu
item “ GENERAL 037 MEM GROUP ”.
Rotate the [ CLAR/VFO-B
] knob to set this Menu item
to “ENABLE” (the default setting is “DISABLE”).
3. Press and hold in the [ MNU
] key for two seconds to
save the new setting and exit. Operation will now be
restricted to the six Memory Groups.
To cancel Memory Group operation, repeat steps (1)
through (3) above, choosing “DISABLE” in step (2).
A A A A A
D D
D D
DVICE VICE
VICE VICE
VICE
Note that for the PMS memory group, the PMS
memories “P1L” through “P9U” will be so desig-
nated, so as to avoid confusion.
C
HOOSING THE
D
ESIRED
M
EMORY
G
ROUP
You may recall memories just within a particular Memory Group, if desired.
Memory Channel Number
Groups Memory “OFF” Groups Memory “ON”
01 ~ 19 1-01 ~ 1-19
20 ~ 39 2-01 ~ 2-20
40 ~ 59 3-01 ~ 3-20
60 ~ 79 4-01 ~ 4-20
80 ~ 99 5-01 ~ 5-20
P-1L/1U ~ P-9L/9U P-1L/1U ~ P-9L/9U
[CLAR/VFO-B] Knob
[MNU] Switch
[MAIN Tuning Dial] knob
[CLAR/VFO-B] Knob
[MCH-GRP] Switch
1. Press the [ V/M
] key, if necessary, to enter the Memory
mode.
2. Press and hold in the [ MCH/GRP
] key (below and to
the left of the [ CLAR/VFO-B
] knob for two seconds.
The imbedded LED inside the switch will light up.
3. Rotate the [ CLAR/VFO-B
] knob to select the desired
Memory Group.
To exit from Memory Group operation, press and hold in
the [
MCH/GRP
] key for two seconds once more.
A A A A A
D D D D DVICE VICE VICE VICE VICE
You will now be operating using memories only
within the selected Memory Group.
If no channels have been assigned to a particu-
lar Memory Group, you will not have access to
that Group.
VDD TEMP SWR BIAS
VDD TEMP SWR BIAS
[V/M] Switch