XTBA DALI Watch Manual Page
24
of
26
Product # - 03/2013
© XTBA 1986 – 2013
The XTBA QUICK SET UP GUIDE TO DALI
If you have just walked into an installation, you are in a hurry and the client is
in the corner sharpening an axe, then the following might be useful to save
you reading through the delights of the entire manual!
Installation installed and connected but not set up or much else?
1 - Plug in the mains adaptor first and then connect the XTBA DALI Watch to
any point of the DALI cable.
2 - Is the blue LED flashing? If no go to 3. If flashing there is no DALI buss
power so you need to add one as follows: Press the function key until:
L O C A L
B U S S
P S U
O F F
Y e s
t o
t o g g l e
Press the Yes key to turn on the power and then the function key to get back
to the main menu loop.
3 – Press the function key until:
D I S C O V E R
P R O G R A M
A L L
y e s
t o
e n t e r
o r
m e n u
4 – Press the Yes button and the message ‘WILL ERASE ALL DATA’ will be
displayed. Press Yes again to start discovery.
5 – The XTBA DALI Watch will erase all data and discover the first device, at
the end of the search the device to be programmed will be lit to 50% and the
display will go to:
S . A D D R E S S
=
1
m e N u = r e j e c t y e s = s e n d
Using the up/down keys set the address you would like the device to be and
then press Yes.
6 – Repeat step 5 until COMPLETE (number of devices) FOUND displays.
7 – The devices will have had their defaults set in discovery as follows:
Power On Level = 1, Minimum Level = 1, System Failure Level = 0, Max Level
= 254. Following discovery you can change these settings in Quick Set Up if
needed.
Check it all worked
8 – Press the Function button until TRANSMIT DALI and press Menu, press
Menu until ADJUST ONE LEVEL appears then press Yes and the display will
change to:
A D D R E S S
1
T O
0 %
L / R =
A D D U / D =
L E V E L