Xstream X-HW13008GENNG, Руководство по эксплуатации

Страница: 17 / 40

17
installation
DANGER
• THIS UNIT MUST BE CONNECTED TO A
PROPERLY GROUNDED OUTLET.
ElECTRICAl
GAS PIPING
1. Installation of this unit should be performed by a qualified serviceman
and all electrical installation must conform to all local, state and
national codes, including NFPA No. 70 (NEC) National Electrical
Code. In Canada; Refer to the CSA C22.1 Canadian Electrical Code
Part 1.
2. This unit comes to you with the wires terminating in a junction box
inside the cabinet. You must supply the incoming power source.
3. Ensure electrical supply is identical to the specifications listed on the
pressure washer data plate.
4. Ensure all connections are secure and covers are replaced.
1. Installation of this unit should be performed by a qualified serviceman
and all gas piping must conform to all local, state and national codes,
including the National Fuel Gas Code ANSI Z223.1/NFPA No. 54. In
Canada; Refer to the CSA B149.1 Gas Installation Code.
2. Turn off gas and electricity before starting installation or service.
3. The gas line to the burner should be a separate supply from the meter
because of the burner demand. Use new pipe and locate it with
future service in mind. Use only black pipe or tubing suitable for gas
applications and make sure the pipe is free from cutting burrs and
defects. Use joint compound (not teflon tape) only on male fittings,
leaving clean the first two threads to be engaged. DO NOT use
compound on female threads where it can be pushed into the line and
cause gas valve failure.
RECOMMENDED PIPE SIZES FOR GAS SUPPLY LINE
NATURAL GAS L.P.-GAS
DISTANCE TO
UNIT FROM
REGULATOR
PIPE SIZE DISTANCE TO
UNIT FROM
REGULATOR
PIPE SIZE
0-50 Feet 1-1/2” 1PS 0-50 Feet 1” 1PS
50-100 Feet 2” 1PS 50-100 Feet 1-1/2” 1PS
100-200 Feet 2-1/2” 1PS 100-200 Feet 1-3/4” 1PS