Xstream X-HW13008GENNG, Руководство по эксплуатации

Страница: 7 / 40

7
safety
WARNING
Serious injury or death may occur from improper
installation.
Serious injury or death may occur from gas leaks.
Serious injury or death may occur from normal sparks in
the multiple ignition sources.
Serious injury or death may occur if system safety’s are
not properly maintained.
• Installation of this unit including all gas piping must comply with all
local, state and national codes. (Standards to be followed include
the National Fuel Gas Code ANSI Z223.1/NFPA No. 54. In Canada;
Refer to the CSA B149.1 Gas Installation Code).
• Use appropriate fuel (natural gas or L.P.-Gas Vapor) for the machine
you are using.
• Do not connect gas lines to the pressure washer before testing gas
piping pressure or there may be damage to the gas valve.
• Do not adjust gas pressure above recommended levels. Excessive
pressure may cause damage to the valve.
• Liquid propane models are designed to run on vapor propane fuel. Do
not use liquid fuel.
• Do not replace or refill L.P.-Gas tank while unit is running.
• If you smell gas, extinguish any open flame and test all joints with a
soap solution. If the odor persists, turn off gas supply and call for
service.
• L.P.-Gas is heavier than air and will gravitate to the floor. Always
provide adequate floor space and ventilation with L.P.-Gas systems
and sniff floor area for gas before operating. Do not operate unit if
smell exists.
• Never leave operating machine unattended.
• When servicing this machine, be especially careful to properly shut off
gas supply.
• Install the pressure washer where open flame or torch is permitted.
• Always operate pressure washer in a well ventilated area free of
flammable vapors, combustible materials including dust or gases.
• Do not allow lint or dust to collect in burner area.
• Do not use this pressure washer to spray flammable liquids!
Flammable liquids can create fumes which can ignite.
• This pressure washer has multiple safety devices which should never
be altered, modified, removed or made inoperative. If a device fails,
replace immediately with only genuine manufacturer replacement part.