Xstream X-HW13008GENNG, Руководство по эксплуатации

Страница: 38 / 40

38
troubleshooting
SYMPTOM PROBABLE CAUSE REMEDY
Detergent will not
siphon.
Detergent strainer is not
completely submerged in
detergent solution.
Check, submerge if necessary.
Detergent strainer
obstructed.
Inspect, clean or replace.
Detergent hose cut,
obstructed or kinked.
Inspect, clean or replace.
Detergent adjusting knob
turned to closed position.
Open adjusting knob. Refer to
“Cleaning with Detergents”.
Water flows back into
detergent container.
Ball and spring in strainer
missing or corroded.
Remove, clean or replace.
Water flows from the
nozzle when the trigger
gun is locked in the
“OFF” position
Trigger gun is
malfunctioning.
Repair or replace.
Before start-up, you
smell gas around the
machine.
Gas is leaking. Go to another location and
call your gas supplier for
instructions, or if you cannot
reach the supplier, call the fire
department.
Burner will not ignite Switch is not turned on. Check switch position.
Thermostat knob is OFF. Check thermostat knob position.
Trigger gun is closed. Open trigger gun for pressure.
Vacuum or pressure switch
failure.
Repair or replace.
Gas valve safety lock-out. Release trigger on gun or switch
burner switch “OFF” for 60
seconds.
Inadequate gas supply. Check gas supply.
Gas line obstruction. Check gas pressure.
Ignition module failure. Replace.
Gas valve failure. Replace.
Water is leaking under
heat exchanger coil.
Condensation. May occur in cool, humid
conditions. coil.
Ruptured heat exchanger
coil.
Replace.