Xstream X-HW13008GENNG, Руководство по эксплуатации

Страница: 32 / 40

32
maintenance
Maintenance Instructions
PREVENTATIVE MAINTENANCE
LEAKS: Promptly eliminate any leaks found in the pumping system by
removing suspect parts, applying thread sealant to the threads and
reinstalling.
QUICK COUPLERS: There are o-ring seals inside the couplers which
will deteriorate. To replace, simply install a replacement o-ring to
correct the leak. (Additional o-rings can be purchased from your
dealer.)
NOZZLE: Water flow through the spray nozzle will erode the orifice,
making it larger, resulting in a pressure loss. Nozzles should be
replaced whenever pressure is less than 85% of the maximum. The
frequency of replacement will depend upon such variables as mineral
content in the water and number of hours the nozzle is used.
PUMP:
1. Change the pump oil after the first 50 hours of operation. After initial
change, every 3 months or 250 hour intervals are recommended.
If oil appears dirty or milky, changes may be required in greater
frequency.
2. Locate the pump oil drain hose.
3. Use an empty container to catch the oil and remove the plug from
the drain line.
4. Let all the oil drain from the pump and replace drain plug. Dispose
of used oil according to local, state and national regulations.
5. Fill the pump crankcase to the notch on the dipstick with pump oil
SAE20 or 30 non-detergent. Do not overfill.
BELT TENSION: Ensure unit is off. Remove the side panel or lift lid to
inspect the v-belt for wear and tightness. If the v-belt needs to be
replaced or tightened, follow the procedures listed.
Replacement:
1. Loosen the four pump mounting bolts (A).
2. Loosen the two alignment nuts approximately one inch on the
alignment bolts (B1 & B2).
3. Slide the pump toward the motor to loosen belts.
4. Remove and replace belt.
NOTICE
If using Teflon tape, be certain no tape gets inside any plumbing to
prevent the possibility of a plugged spray nozzle.