Xstream X-HW13008GENNG, Руководство по эксплуатации

Страница: 29 / 40

29
operation
WARNING
THE WATER TEMPERATURE COULD BECOME VERY HOT DURING
HOT WATER OPERATION. BE CAUTIOUS WHEN ADJUSTING
PRESSURE OR CONTROLLING THE TRIGGER GUN/ LANCE
ASSEMBLY.
NOTICE
The burner is equipped with a safety lock-off device. If the pilot fails
to ignite within 60 seconds, the gas valve locks OFF. Simply release
the trigger for approximately another 60 seconds and repeat. During
operation, the burner may cease and start occasionally because of the
thermostat setting.
ClEANING WITH DETERGENTS
NOTICE
If machine is equipped with remote box (es), read pg. 24 for informa-
tion on detergent solenoid.
This feature is designed for use with mild detergents only. Since the
cleaning solution travels through the heat exchanger coil, do not use
corrosives as they will cause extensive damage as well as pose a
considerable safety hazard.
1. Be certain to wear protective safety attire as stated on pg. 23.
2. Prepare detergent solution according to label directions. (Never pump
acids, alkalines, abrasive fluids or solvents through the unit.)
3. Fully immerse the strainer end of the clear vinyl detergent hose into the
detergent solution.
4. Adjust the amount of detergent desired by turning the detergent
adjustment knob to the desired setting.
5. To apply solution, unlock the trigger gun and squeeze the trigger. In
a few moments a detergent/water mixture will exit the nozzle. Start
spraying the lower portion of the surface being cleaned and move up,
using long overlapping strokes. Applying from the bottom up helps
avoid streaking. Allow to soak briefly. Avoid working on hot surfaces
or in direct sunlight to minimize the chances of the detergent drying,
which may result in damaging surfaces. Be certain to clean a small
section at a time.
6. To rinse, turn the detergent adjustment knob to the OFF position. It will
take about 30 seconds to purge all detergent from the line. For best
rinsing results, start at the top and work down.