Xstream X-HW13008GENNG, Руководство по эксплуатации

Страница: 23 / 40

23
preparation
Preparation
ATTIRE
PRE-START
Proper attire is essential to your safety. It is advised to utilize whatever
means necessary to protect eyes, ears, and skin. Additional safety attire
(such as respiratory mask) may be required when using detergent clean-
ing agents with this pressure washer.
1. Before lighting, smell all around the machine for gas. Especially, sniff
the floor area because some gas is heavier than air and will settle on
the floor. Do not operate unit if smell exists. Leave the location and
contact a qualified serviceman.
2. Check to ensure the voltage is on.
3. Pump oil level should be checked before each use. Check the oil level
with the dipstick on top of the pump crankcase. The proper oil level
should be at the notch on the dipstick. If the level appears low, use
pump oil SAE20 or 30 non-detergent.
DANGER
• SMELL FOR GAS BEFORE STARTING UNIT.
ALWAYS SNIFF AREA AROUND THE MACHINE FOR
A GAS SMELL. BE SURE TO SNIFF FLOOR AREA,
SINCE SOME GAS IS HEAVIER THAN AIR AND WILL
SETTLE ON THE FLOOR.
• IF YOU SMELL GAS :
• DO NOT START UNIT.
• DO NOT OPERATE ANY ELECTRICAL SWITCH.
• DO NOT LIGHT ANY APPLIANCE.
• DO NOT USE ANY PHONE IN THE ROOM OR
AREA.
• LEAVE, GO TO ANOTHER LOCATION AND USE A
PHONE TO CALL YOUR GAS SUPPLIER.
• FOLLOW THE GAS SUPPLIER’S INSTRUCTIONS.
• IF YOU CANNOT REACH YOUR GAS SUPPLIER,
CALL THE FIRE DEPARTMENT.
8 Operator's Manual
preparation
attire:
Proper attire is essential to your safety. It is advised to utilize whatever means
necessary to protect eyes, ears, and skin. Additional safety attire (such as
respiratory mask) may be required when using detergent cleaning agents with
this pressure washer.
pre-start:
. Before lighting, smell all around the machine for gas. Especially, sniff the
floor area because some gas is heavier than air and will settle on the floor.
Do not operate unit if smell exists. Leave the location and contact a qualified
serviceman.
2. Check to ensure the voltage is on.
3. Pump oil level should be checked before each use. Check the oil level with
the dipstick on top of the pump crankcase. (See illustration #0.) The proper
oil level should be at the notch on the dipstick. If the level appears low, use
pump oil SAE20 or 30 non-detergent.
illustration #10
pump-rear oil gauge
DANGER
risK of eXplosion or fire!
unloader:
The unloader has been preset at the factory and should only be adjusted by a
trained serviceman.
SMELL FOR GAS BEFORE
STARTING UNIT. ALWAYS SNIFF
AREA AROUND THE MACHINE
FOR A GAS SMELL. BE SURE TO
SNIFF FLOOR AREA, SINCE SOME
GAS IS HEAVIER THAN AIR AND
WILL SETTLE ON THE FLOOR.
if you smell gas:
•
DO NOT START UNIT.
•
DO NOT OPERATE ANY
ELECTRICAL SWITCH.
•
DO NOT LIGHT ANY
APPLIANCE.
•
DO NOT USE ANY PHONE IN
THE ROOM OR AREA.
•
LEAVE, GO TO ANOTHER
LOCATION AND USE A PHONE
TO CALL YOUR GAS
SUPPLIER.
•
FOLLOW THE GAS SUPPLIER'S
INSTRUCTIONS.
•
IF YOU CANNOT REACH YOUR
GAS SUPPLIER, CALL THE FIRE
DEPARTMENT.
pump
-
rear oil gauge
1.
oil fill and dipstick
2.
oil drain plug