Xerox PHASER 5400, Руководство по расширенным функциям и устранению неисправностей

Страница: 91 / 127

Advanced Features and Troubleshooting Manual 75
Networking
Step-by-step setup (AppleTalk)
Configuring EtherTalk at the control panel
To enable the EtherTalk protocol at your printer’s control panel, follow these steps:
1. Press Menu Up or Menu Down until you see:
Menus
Ethernet Menu
2. Press Item Up or Item Down until you see:
Ethernet Menu
EtherTalk Enable
3. Press Value Up or Value Down . You should see:
EtherTalk Enable
On
4. Press Enter . You should see:
Ethernet Menu
EtherTalk Enable
5. Press On Line . You should see:
Ready
6. Restart the printer.
Selecting the printer from the Chooser
Before you send a print job to the Phaser 5400 printer, make sure that it is selected as the
current printer in the Chooser.
1.
At the printer, print a Configuration Sheet and note the EtherTalk Name. Refer to the
Quick Network Install Guide for instructions.
2.
At your computer, select the APPLE in the upper left corner of the Desktop.
3.
Select the
Chooser
entry in the menu.
4.
Make sure that
AppleTalk
is active.
5. In the left window of the Chooser, click on the Adobe PS icon to select it. You may
have to use the scroll bars at the right side of this box to locate the icon.
Note
Your network may be divided into AppleTalk Zones. You can tell if there are
zones by the appearance of the CHOOSER window. When the CHOOSER
program detects multiple zones, the left window is reduced in size. The lower
half of the CHOOSER window is a zone list. Identify, then select the zone in
which the Phaser 5400 printer is located.